Electrical Specification

Fig 1: Identifying Engine Control Module I/O Signal Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.

ECM CONNECTOR TERMINAL DESCRIPTION

Description		Terminal No.	Measurement condition and I/O signal (Idling with ignition ON: except for cruise set light)
Main power supply	VB (CONTROL 1) VB (CONTROL 2)	A7, B2	Battery voltage is detected when the main power is turned ON. "0 V" is detected when the main power is turned OFF.
Command switch		B24	"0 V" is detected when the command switch is in CANCEL position. "Approx. 1 V" is present when the command switch is in SET/COAST position. "Approx. 3 V" is detected when the command switch is in RESUME/ACCEL position. "Approx. 4 V" is detected when the command switch is released.
Brake switch 1 (Brake switch)		B20	Battery voltage is detected when the brake pedal is released. "0 V" is present when brake pedal is depressed.
Brake switch 2 (Stop light switch)		B28	Battery voltage is present when brake pedal is depressed. "0 V" is detected when the brake pedal is released.
Main switch		B12	"0 V" is present while the main switch is pressed or turned on. Approx. "5 V" is detected when the main switch is turned to OFF.
Ground	GND (CONTROL 1)	A5	-
Ground	GND (CONTROL 2)	D7	-
Ignition switch		B19	Battery voltage is detected when the ignition switch is turned ON. "0 V" is detected when the ignition switch is turned OFF.
Clutch switch (MT model)		C25	"0 V" is present when brake pedal is depressed. Battery voltage is detected when the clutch pedal is released.
Neutral position switch (MT model)		C31	Battery voltage is detected when the shift lever is in any position except for neutral. "Approx. 0 V" is detected when the shift lever is in neutral position.
Neutral signal (AT model)		C31	Battery voltage is detected when the shift lever is in any position except for "P" or "N". "0 V" is detected when the shift lever is in "P" or "N" position.