LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control (VDC) (Diagnostics) >> Basic Diagnostic Procedure >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Basic Diagnostic Procedure: Procedure

NOTE:
  • To check the harness for open or short circuits, shake problem spot or connector.
  • Refer to CHECK LIST FOR INTERVIEW .
BASIC DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK PRE-INSPECTION. 
  1. Ask the customer when and how the trouble occurred using the interview check list. Ref. to CHECK LIST FOR INTERVIEW .
  2. Before performing diagnostics, check the component which might affect VDC problems. Ref. to INSPECTION , General Description.
 Is the component that might influence the VDC problem normal? Go to step 2  . Repair or replace each component.
2 CHECK INDICATION OF DTC. 
  1. Turn the ignition switch to OFF.
  2. Connect the Subaru Select Monitor to data link connector.
  3. Turn the ignition switch to ON and run the Subaru Select Monitor.
  4. Read the DTC. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC).
    NOTE: If the communication function of the Subaru Select Monitor cannot be executed normally, check the communication circuit. Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , INSPECTION, Subaru Select Monitor.
  5. Record all DTCs and freeze frame data.
 Is DTC displayed? Go to step 4  . Go to step 3  .
3 PERFORM GENERAL DIAGNOSIS. 
  1. Perform the inspection by referring to "General Diagnostic Table". Ref. to INSPECTION , General Diagnostic Table.
  2. Perform the Clear Memory Mode. Ref. to OPERATION , Clear Memory Mode.
  3. Perform the Inspection Mode. Ref. to PROCEDURE , Inspection Mode.
  4. Read the DTC. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC).
  5. Check the DTC is not displayed.
 Do the VDC warning light and ABS warning light go off after starting the engine? Finish the diagnosis. Check the combination meter circuit. Ref. to ABS WARNING LIGHT DOES NOT GO OFF , Warning Light Illumination Pattern. Ref. to VDC WARNING LIGHT, TCS OFF INDICATOR LIGHT AND VDC INDICATOR LIGHT DO NOT COME ON , Warning Light Illumination Pattern.
4 PERFORM DIAGNOSIS. 
  1. Refer to "List of Diagnostic Trouble Code (DTC)".
    NOTE: For the DTC list, refer to "List of Diagnostic Trouble Code (DTC)". Ref. to LIST , List of Diagnostic Trouble Code (DTC).
  2. Correct the cause of trouble.
  3. Perform the Clear Memory Mode. Ref. to OPERATION , Clear Memory Mode.
  4. Perform the Inspection Mode. Ref. to PROCEDURE , Inspection Mode.
  5. Read the DTC. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC).
 Is DTC displayed? Repeat step 4 until DTC is not shown. Finish the diagnosis.
scientia non olet · About LEMON Manuals