General Scan Tool
- After performing the diagnostics and clearing the memory, check for any remaining unresolved trouble data. Ref. to CLEAR MEMORY MODE .
- Warm up the engine.
- Connect the delivery (test) mode connector (A) located under the glove box.
- Connect the Subaru Select Monitor to the data link connector at the lower portion of instrument panel (on the driver's side).CAUTION: Do not connect any scan tools other than Subaru Select Monitor or general scan tool.
- Start the engine.NOTE: Ensure the selector lever is placed in "P" range before starting.
- Turn the neutral position switch to ON using select lever.
- Depress the brake pedal to turn the brake switch ON.
- Keep the engine speed in 2,500 - 3,000 rpm range for 40 seconds.
- Shift the select lever in the "D" range and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis system.
- Using the general scan tool, check DTC and record the result(s).NOTE:
- For detailed operation procedures, refer to the general scan tool operation service information.
- For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".
.