Idle Speed Control
CAUTION:
After executing the operation check mode, execute the Clear Memory Mode. Ref. to
OPERATION , Clear Memory Mode.
- On the «System Operation Check Mode» display screen, select the {Idle Speed Control}.
- On the «Start the Engine» display screen, start the engine and click the [OK] button.
- In the «Idle Engine Speed Control» screen, click the [
] button or the [
] button to change the setting values, then click the [OK] button.
Setting is possible in a range between 500 rpm - 2,000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle.
- Click the [Cancel] button to stop the idle speed control.
- Click the [[F12] Exit] button to end the idle speed control. The display will then return to the «System Operation Check Mode» screen.NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR .