Engine Control Module (ECM) Reprogramming (WVT-30)

Publication date: 2010-08-01
Reference number: WVT-30

ENGINE CONTROL MODULE (ECM) REPROGRAMMING

SERVICE CAMPAIGN BULLETIN

Reference Number(s): WVT-30, Date of Issue: August, 2010

SUBARU:

2011 Legacy, Outback, Impreza

INTRODUCTION

Subaru of America, Inc. has determined that vehicles affected by this Service Program require ECM reprogramming.

A modification to the Engine Control Module software logic has been developed to improve the performance of the emission control system. This software change will not adversely affect fuel economy or performance.

AFFECTED VEHICLES

2011 MY Subaru Legacy, Outback, Impreza (including WRX & STI)

Affected vehicles are identified in the VIN range chart below.

NOTE: Since some vehicles have been reprogrammed prior to shipment to dealers, not all vehicles in the VIN ranges are affected. Prior to performing repairs, confirm coverage by using the Vehicle Coverage Inquiry function at Subarunet.com.

VIN RANGE

MODEL

FROM

2011MY

Legacy Sedan

B⁽¹⁾210001

B⁽¹⁾216063

Outback

B⁽¹⁾310001

B⁽¹⁾329361

Impreza Sedan

B⁽¹⁾500001

B⁽¹⁾503923

Impreza 5 Door

B⁽¹⁾800002

B⁽¹⁾806803

⁽¹⁾	Various characters may occupy this position of the VIN.

OWNER NOTIFICATION

SOA will prepare and mail an Owner Notification Letter to owners of affected vehicle on or around August 20, 2010.

A copy of the Owner Notification Letter is included at the end of this bulletin.

DEALER PROGRAM RESPONSIBILITY

Dealers are to promptly perform the applicable service procedures defined in this bulletin to correct all affected vehicles in their inventory (new, used, demo). Additionally, whenever a vehicle subject to this Service Program is taken into dealer new or used inventory, or is in the dealership for service, necessary steps should be taken to ensure the Service Program correction has been made before selling or releasing the vehicle.

New or used vehicles listed in a Service Program that are in dealer stock must be:

Immediately identified.
Tagged or otherwise marked to prevent their delivery or use prior to repair.
Repaired in accordance with the repair procedures outlined in this Service Program Bulletin.

REPAIR PARTS

No repair parts are needed to perform this procedure.

SPECIAL TOOLS

Vehicle ECM reprogramming will require the following:

Subaru Diagnostic System (SDS)

SDS Toughbook
Subaru Select Monitor III (SSMIII Application Software)
Subaru Diagnostic Interface Box (SDI)
USB Data Link Cable and Reprogramming Cable.

NOTE: If you require assistance with using the Subaru Diagnostic System (SDS), use the "Help" function icon, which will allow you to access the tutorial information.

SERVICE PROCEDURE

This service procedure will involve completing the following two (2) steps:

Check ECM memory for diagnostic trouble codes.
Reprogram ECM with updated pak file.

Check ECM memory for diagnostic codes.
Using the appropriate Subaru Diagnostics System (SDS) components, connect to the vehicle's Diagnostic Link Connector (DLC) located in the vehicle's lower left dash panel.

Select the Select Monitor Icon from the SDS Graphical User Interface (GUI).

The Main Menu will appear.
1. Select Each System Check.
2. Select Engine Control System.
3. Select Diagnostic Code(s) Display.
4. Select Memorized Diagnostic Code(s).
5. Search results will appear Proceed as follows:
If no codes are found , proceed to the "ECM Reprogramming Instructions" beginning on this page.

If trouble codes are found , make any necessary repairs and clear all codes prior to reprogramming the ECM.
ECM Reprogramming Instructions
Confirm that your SSM-III contains the August 2010 Flashwrite File Update, which includes the following reprogramming PAK files.

Version Numbers

Software: 1.23.38.7 or higher

Interface Box: 1.6.7 or higher

Interface Box CF Card: 1.2.67 or higher

Use the following PAK file to reprogram the ECM:

PARTS INFORMATION

VEHICLE	TRANSMISSION	NEW ECM/PAK FILE PART NUMBER
2011MY Legacy & Outback 2.5L NA CA Spec. PZEV	CVT	22765AB07B.pak
2011MY Legacy & Outback 2.5L NA CA Spec. PZEV	6MT	22765AB06B.pak
2011MY Legacy & Outback 2.5L NA FED Spec.	CVT	22765AB09B.pak
2011MY Legacy & Outback 2.5L NA FED Spec.	6MT	22765AB08B.pak
2011MY Legacy 2.5L Turbo CAL & FED Spec.	6MT	22765AB11B.pak
2011MY Legacy & Outback 3.6L NA CA Spec.	5AT	22765AB12B.pak
2011MY Legacy & Outback 3.6L NA FED Spec.	5AT	22765AB13B.pak
2011MY Impreza 2.5L NA CA & FED Spec.	5MT	22765AB011.pak
2011MY Impreza 2.5L NA CA & FED Spec.	4AT	22765AB021.pak
2011MY Impreza WRX 2.5L Turbo CA & FED Spec.	5MT	22765AB201.pak
2011MY Impreza STI 2.5L Turbo CA & FED Spec.	6MT	22765AB211.pak

STATE EMISSION TESTING ADVISORY

After ECM reprogramming, the OBD system's readiness code monitors will set to "incomplete". Normally, the vehicle needs to be driven under a variety of conditions before the readiness code monitors will indicate "complete". (See State I/M Program Advisory Bulletin number 11-72-04, dated 8/4/04 for details.)

SERVICE PROGRAM IDENTIFICATION LABEL

Type or print the necessary information on a Service Program identification label. The completed label should be attached to the vehicle's upper radiator support.

Additional labels are available through the Subaru Claims Helpline at 1-866-782-2782.

Fig 1: Identifying Service Program Identification Label

CALIFORNIA "VEHICLE EMISSION RECALL - PROOF OF CORRECTION" CERTIFICATE

The California Air Resources Board and the Department of Motor Vehicles Registration/Recall Program requires that all emission related Recall/Campaign or Service Program repairs be completed before a vehicle registration is renewed. Please provide owners of vehicles registered in the state of California a completed "Vehicle Emission Recall - Proof of Correction" certificate. Vehicle owners should be advised to retain this certificate because the California Department of Motor Vehicles may require they provide proof this service program repair has been completed.

Fig 2: Proof Of Correction Certificate

CLAIM REIMBURSEMENT AND ENTRY PROCEDURES

Credit to perform this Service Program will be based on the submission of properly completed repair order information. Dealers may submit claims through Vehicle Claim Entry on Subarunet.

CLAIM INFORMATION

CLAIM TYPE	CAMPAIGN CODE	LABOR	LABOR DESCRIPTION
RC	WVT-30	145-580 - 0.6	Reprogram ECM.

OWNER NOTIFICATION LETTER

Service Program WVT-30

Engine Control Module Reprogramming

Dear Subaru Owner:

We would like to thank you for selecting a 2011 Subaru. At Subaru, we take pride in our products and are committed to your continued satisfaction.

Subaru has developed a modification to the Engine Control Module software logic that will improve the performance of your vehicle's emission control system. This software change will not adversely affect fuel economy or performance.

WHAT WE ARE ASKING YOU TO DO PROMPTLY

We suggest that you schedule an appointment with your Subaru Dealer as soon as possible to have your vehicle's Engine Control Module software reprogrammed. This will take approximately 40 minutes to complete. However, it may be necessary for you to leave your car longer on the day of your appointment to allow your dealer flexibility in scheduling. Your Subaru dealer will perform this modification at no cost to you.

Please present this letter to your Subaru Dealer on the day of your service appointment.

CALIFORNIA REGISTERED OWNERS

The California Air Resources Board requires that emission related campaigns be completed prior to California's vehicle registration renewal process; without this repair, you will not be able to register your vehicle during your next annual registration. Upon completion of this campaign, your California dealer will complete and provide you a "Proof of Correction Certificate." If required, present the certificate to the California Department of Motor Vehicles (the "DMV") when renewing your California registration as proof of campaign completion. If the DMV does not request the certificate, we recommend that you keep it for your records.

In addition, the State of California requires that every vehicle must pass an emission test (SMOG Check) every two years and before it is sold. Without the free service we are providing, your vehicle may be more likely not to pass this test and require that you make costly repairs.

CHANGED YOUR ADDRESS OR SOLD YOUR SUBARU?

If you have changed your address, or if you have sold your Subaru, please complete the enclosed prepaid postcard and mail it to us.

IF YOU NEED FURT HER ASSISTANCE

To locate the nearest Subaru Dealer you can access our website at www.subaru.com and select "Find a Dealer".

If you need additional assistance, please contact us directly:

Telephone: 1-800-SUBARU3 (1-800-782-2783) Monday through Thursday between 8:30 a.m. and 7:00 p.m. EST and Friday between 10:30 a.m. and 5:00 p.m. EST.
E-mail: Go to www.subaru.com and select "Contact Us".
U.S. Postal mail: Write us at: Subaru of America, Inc., Attn: CDS Department, P.O. Box 6000, Cherry Hill, NJ 08034-6000.

Please contact us immediately if the dealer fails or is unable to make the necessary repairs free of charge.

Your continued satisfaction with Subaru is important to us. This update is intended to ensure your vehicle's optimal performance. We appreciate your understanding in this matter and regret any inconvenience this may cause you.

Sincerely,

Subaru of America, Inc.

Notice to Lessors

The lessor of a vehicle who receives this letter is requested to provide a copy of it to the vehicle lessee(s) within 10 business days from receipt. The lessor should also keep a record of the lessee(s) to whom this letter is sent, the date sent, and the applicable vehicle identification number (VIN). (For the purposes of this section, a lessor means a person or entity that in the last twelve months prior to the date of this notification has been the owner, as referenced on the vehicle's title, of any five or more leased vehicles. A leased vehicle is a vehicle leased to another person for a term of at least four months.)

A subsidiary of Fuji Heavy Industries Ltd.