Torque Converter Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Install the O-ring to front reduction drive gear.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-ring.
While holding the torque converter assembly by hand, carefully install it into the torque converter case.
NOTE:
- Apply CVTF to the oil seal lip.
- Do not damage the oil seal and O-ring.
Insert the torque converter assembly along the splines completely by gently rotating it manually.
Measure depth "A", from converter case end surface to drive plate contacting surface.
Standard (A) (reference):

6.8 mm (0.268 in)

Fig 1: Identifying Depth "A" From Converter Case End Surface To Drive Plate Contacting Surface
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.