Intake Manifold: Disassembly: Assembly

Liquid gasket: 

THREE BOND 1105 (Part No. 004403010) or equivalent 

Tightening torque: 

17 N.m (1.7 kgf-m, 12.5 ft-lb) 

1. Install the purge control solenoid valve. Refer to PURGE CONTROL SOLENOID VALVE INSTALLATION, Purge Control Solenoid Valve.
2. Install the manifold absolute pressure sensor. Refer to INSTALLATION , Manifold Absolute Pressure Sensor.
3. Install the EGR valve. Refer to INSTALLATION , EGR Valve.
4. Install the fuel pipe assembly.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

   Fig 1: Locating Fuel Pipe Assembly Upper Bolts

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Locating Fuel Pipe Assembly Lower Bolts

   Courtesy of SUBARU OF AMERICA, INC.
5. Install the fuel injector pipe and the fuel hose.
   NOTE: Use a new fuel hose.

   Tightening torque: 

   1.25 N.m (0.1 kgf-m, 0.9 ft-lb) 

   Fig 3: Locating Fuel Injector Pipe And Fuel Hose (RH Side)

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 4: Locating Fuel Injector Pipe And Fuel Hose (LH Side)

   Courtesy of SUBARU OF AMERICA, INC.
6. Install the engine harness to the intake manifold. Refer to ENGINE HARNESS , COMPONENT, General Description.

E: INSPECTION 

1. Check that the intake manifold and fuel pipe have no deformation, cracks and other damages.
2. Check that the hose has no cracks, damage or loose part.