- Prepare the Subaru Select Monitor kit. < Refer to
PREPARATION TOOL , General Description.>
Courtesy of SUBARU OF AMERICA, INC.
- Prepare the personal computer which has been installed the Subaru Select Monitor.
- Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
NOTE:
The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
- Connect the diagnosis cable to the SDI.
- Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
- Start up the personal computer.
- Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
- Call up DTC and data, then record them.
NOTE:
For detailed operation procedure, refer to the PC application help for Subaru Select Monitor.