Registration Of Keyless Transmitter With SUBARU Select Monitor
NOTE:
- A maximum of four keyless transmitter can be registered for each individual vehicle.
- When replacing or adding the keyless transmitter, new registration of transmitter is necessary.
- Prepare the Subaru Select Monitor kit. Refer to , SPECIAL TOOL , PREPARATION TOOL, General Description.
- Prepare PC with Subaru Select Monitor installed.
- Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
- Connect the diagnosis cable to SDI.
- Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.
- Start the PC.
- Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
- On the << Main Menu >> of the Subaru Select Monitor, select the {Each System Check} → {Integ. unit mode} → {Keyless ID registration}.
- Input the 8-digit ID number attached to the tag plate of the transmitter or inside the transmitter, from left to right. Press the [OK] key.
- The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag or inside of transmitter.
- Press the [OK] key if the ID number is correct. Press the [EXIT] key if incorrect, to return to the step 3 and enter the ID number again.
- << ID is being registered...> is displayed and registration starts.
- << ID registration completed >> will be displayed when the registration process is done.
- To exit, select << Quit: NO >> to return to {Keyless ID registration}. If there are additional keyless transmitters to be registered, select << The following are registered: OK >> to return to the step 4.NOTE:
- If the registration fails, << ID cannot register. Try again.> will be shown. Select the [OK] key to return to the {Keyless ID registration}. Retry starting from the step 3.
- << Quit: NO >> is shown on the Subaru Select Monitor when fourth keyless transmitter has been registered. Select the [NO] key to return to {Keyless ID registration}.