Clear Memory Mode

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Shift the select lever to "P" range.
On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu», select {Transmission Control System}.
After transmission type information pops up, select [OK].
On the «Transmission Diagnosis» display screen, select {Clearing Memory}.
When "Done. Turn ignition switch to OFF" pops up, select [OK].
Turn the Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for more than 10 seconds.
NOTE:
- To clear the previous DTC, use {Clearing Memory}, and to clear the learned value, use {Clear Memories 2}.
- For details concerning the operation procedure, refer to SUBARU SELECT MONITOR .