Front Lateral Link: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to use a new self-locking nut.
Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

Install in the reverse order of removal.
Tightening torque:

Front lateral link to Sub frame

120 N.m (12.2 kgf-m, 89 ft-lb)

Front lateral link to Rear axle housing.

60 N.m (6.1 kgf-m, 44 ft-lb)
Inspect the wheel alignment and adjust if necessary.