Rear Brake Pad: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Apply a thin coat of Molykote M7439 (Part No. K0770YA000) or grease contained in the pad kit to the pad clip.

Fig 1: Applying Thin Coat Of Molykote M7439 (Part No. K0770YA000) Or Grease Contained In Pad Kit To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or the grease contained in the pad kit to the contact surface between the outer-side pad and shim.

Fig 2: Applying Thin Coat Of Molykote AS880N (Part No. K0777YA010) Or Grease Contained In Pad Kit To Contact Surface Between Outer-Side Pad And Shim
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to both surfaces of the inner pad inner shim.

Fig 3: Applying Thin Coat Of Molykote AS880N (Part No. K0777YA010) Or Grease Contained In Pad Kit To Both Surfaces Of Inner Pad Inner Shim
Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
Install the caliper body to the support.
Tightening torque:

27 N.m (2.8 kgf-m, 19.9 ft-lb)
Install the brake hose bracket.

Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)