Ignition Key Lock: Inspection
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument panel lower cover.
- Remove the lower column cover.
- Unfasten the fixing clip which secures harness, and then disconnect the connector of the ignition switch from body harness.
- Turn the ignition key plate to each position and check the continuity between terminals of ignition connector.
| Switch position | Terminal No. | Standard |
|---|---|---|
| LOCK | - | - |
| ACC | No. 3 and No. 4 | Less than 1 Ω |
| ON | No. 3, No. 1 and No. 4 No. 3 and No. 6 | Less than 1 Ω |
| ST | No. 3 and No. 1 No. 3, No. 2 and No. 6 | Less than 1 Ω |
If NG, replace the ignition switch.