Check Ignition Switch Illumination

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Step	Check	Yes	No
1 CHECK FUSE. Remove and visually check the fuse No. 14 (in the main fuse box).	Is the fuse blown out?	Replace the fuse with a new part.	Go to step 2.
2 CHECK POWER SUPPLY. Disconnect the ignition switch illumination harness connector (B414). Measure the voltage between harness connector terminal and chassis ground. Connector & terminal (B414) No. 2 (+) - Chassis ground (-):	Is the voltage 10 V or more?	Go to step 3.	Check the harness for open circuits and shorts between the ignition switch illumination and fuse.
3 CHECK IGNITION SWITCH ILLUMINATION CIRCUIT. Disconnect the body integrated unit harness connector (B280) and ignition switch light harness connector (B414). Measure the resistance between body integrated unit harness connector terminal and ignition switch illumination harness connector terminal. Connector & terminal (B280) No. 4 - (B414) No. 1:	Is the resistance less than 10 Ω?	Replace the ignition switch illumination bulb with a new part. Refer to IGNITION SWITCH ILLUMINATION REMOVAL, Ignition Switch Illumination.	Check the harness for open circuits and shorts between the body integrated unit and ignition switch illumination.