LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Fuel Injection Fuel Systems (H6DO)) >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the knock sensor to the cylinder block.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    NOTE: For the knock sensor installation angle, refer to the figure below.
    Fig 1: Identifying Knock Sensor Installation Angle
    G07912320Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the knock sensor connector.
  3. Install the intake manifold. Refer to , INSTALLATION , Intake Manifold.
  4. Connect the battery ground terminal.
  5. Install the collector cover.
scientia non olet · About LEMON Manuals