LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission) >> Oil Charge Pipe >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Charge Pipe: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil charge pipe.
    NOTE: Use new gaskets and O-rings.

    Tightening torque: 

    38 N.m (3.9 kgf-m, 28.0 ft-lb) 

    Fig 1: Identifying ATF Level Gauge And Oil Charge Pipe
    G07914806Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector to the turbine speed sensor 1.
  3. Install the front exhaust pipe. Refer to FRONT EXHAUST PIPE .
  4. Install the under cover. Refer to FRONT UNDER COVER .
  5. Lower the vehicle.
  6. Connect the ground cable to battery.
scientia non olet · About LEMON Manuals