Cruise Control Command Switch: Inspection
- Disconnect the cruise control command switch connector.
- Check the resistance between cruise control command switch terminals.
Preparation tool: Circuit tester
Courtesy of SUBARU OF AMERICA, INC.
Terminal No. Inspection conditions Standard 3 - 4 CANCEL
SET/-
RES/+All OFF Approx. 4 kΩ 3 - 4 CANCEL ON Less than 1 Ω 3 - 4 SET/- ON Approx. 250 Ω 3 - 4 RES/+ ON Approx. 1470 Ω 2 - 4 CRUISE (MAIN) OFF 1 MΩ or more 2 - 4 ON Less than 1 Ω - Replace the cruise control command switch if the inspection result is not within the standard value.