LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Air Bag System) >> Airbag Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if the fault occurs by water, replace the airbag control module with a new part.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the center console. Refer to REMOVAL , Center Console.
  4. Remove the console box. Refer to REMOVAL , Console Box.
  5. Remove the instrument panel lower cover. Refer to REMOVAL , Instrument Panel Lower Cover.
  6. Remove the glove box. Refer to REMOVAL , Glove Box.
  7. Remove the audio unit. Refer to REMOVAL , Audio
  8. Remove the screws, and remove the center console frame.
    Fig 1: Locating Center Console Frame Screws
    G05033181Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connector from airbag control module.
  10. Remove the bolts and remove airbag control module.
    Fig 2: Locating Airbag Control Module Bolts
    G05020505Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals