Front Door Glass: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door trim. Ref. to REMOVAL , Door Trim.
Remove the sealing cover. Ref. to REMOVAL , Front Sealing Cover.
Connect the battery ground cable and power window switch connector.
Operate the power window switch to move the glass to the position shown in the illustration, and then remove the two bolts through service holes.

Fig 1: Locating Service Holes Bolts
Courtesy of SUBARU OF AMERICA, INC.
Tilt the door glass forward, then remove the door glass from the glass run rubber.
Remove the door glass.
CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removing glass.
- Avoid impact and damage to the glass.
  
  Fig 2: Removing Door Glass
  Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt (A), and then remove the door sash (B).

Fig 3: Locating Bolt And Door Sash
Courtesy of SUBARU OF AMERICA, INC.