Read Current Data
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
- On Main Menu display, select {Each System Check}.
- On System Selection Menu display, select {Brake Control System}.
- Click the [OK] button after {VDC} is displayed.
- On Brake Control Diagnosis display, select {Current Data Display & Save}.
- On Data Display Menu display, select the data display method.
- Using the scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.
| Display | Contents to be displayed | Unit of measure |
|---|---|---|
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed. | km/h or MPH |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed. | km/h or MPH |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed. | km/h or MPH |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed. | km/h or MPH |
| Longitudinal G Sensor | Vehicle longitudinal acceleration detected by G sensor is displayed. | m/s2 |
| Lateral G Sensor | Vehicle lateral acceleration detected by G sensor is displayed. | m/s2 |
| IG power supply voltage | Voltage supplied to VDCCM&H/U is displayed. | V |
| Steering Angle Sensor | Steering angle detected by steering angle sensor is displayed. | deg |
| Yaw Rate Sensor | Vehicle angular speed detected by yaw rate sensor is displayed. | deg/s |
| Pressure Sensor | Brake fluid pressure detected by pressure sensor is displayed. | bar |
| ABS Control Flag | ABS control condition is displayed. | ON or OFF |
| EBD Control Flag | EBD control condition is displayed. | ON or OFF |
| Brake Switch | Brake ON/OFF is displayed. | ON or OFF |
| ABS Warning Light | ON operation of the ABS warning light is displayed. | ON or OFF |
| EBD Warning Light | ON operation of the EBD warning light is displayed. | ON or OFF |
| Motor Relay Signal | Motor relay operation signal is displayed. | ON or OFF |
| Motor Relay Monitor | Motor relay monitor signal is displayed. | ON or OFF |
| TCS Control Flag | TCS control condition is displayed. | ON or OFF |
| Valve Relay Signal | Valve relay operation signal is displayed. | ON or OFF |
| VDC Control Flag | VDC control condition is displayed. | ON or OFF |
| VDC Warning Light | ON operation of the VDC warning light is displayed. | ON or OFF |
| OFF Lamp | ON/OFF condition of TCS OFF indicator light is displayed. | ON or OFF |
| E/G Control Stop Flag | Engine control command signal is displayed. | 1 or 0 |
| OFF SW Signal | Operation condition of TCS OFF switch is displayed. | ON or OFF |
| Fail Safe Relay Signal | Motor fail safe relay operation signal is displayed. | ON or OFF |
NOTE:
For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".