Pipe Assembly: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
Tightening torque: Refer to POWER ASSISTED SYSTEM , COMPONENT, General Description.
Fill with the specified fluid.
CAUTION: Never start the engine before filling with fluid; otherwise the vane pump may become seized.
Finally, check the clearance between pipes or hoses as shown in the figure indicated in "General Diagnostic Table". Refer to INSPECTION OF CLEARANCE , INSPECTION, General Diagnostic Table.