LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Anti-Theft System - Security And Locks) >> Keyless Entry System >> Inspection >> Check Door Lock Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Door Lock Switch

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
Step Check Yes No
1 CHECK DOOR LOCK SWITCH. 
Check the input signal from door lock switch to body integrated unit using Subaru Select Monitor.
  1. Prepare the Subaru Select Monitor kit.
  2. Turn the ignition switch to ON (engine OFF), and run the "Application for Subaru Select Monitor III".
  3. On the System Selection Menu, select the {Integ. unit mode}.
  4. Select the {Current Data Display & Save}.
  5. Check the input signal to body integrated unit by operating the door lock switch.
 Is the normal input signal displayed when the door lock switch is moved to LOCK/UNLOCK? The door lock switch is OK. Go to step 2. 
2 CHECK DOOR LOCK SWITCH CIRCUIT. 
  1. Disconnect the harness connector of body integrated unit (i84).
  2. Measure the resistance between the harness connector terminal and chassis ground when moving the door lock switch to LOCK.

Connector & terminal 
(i84) No. 15 - Chassis ground: 		 Is the resistance less than 10 Ω? Go to step 3.  Go to step 4. 
3 CHECK DOOR LOCK SWITCH CIRCUIT. 
Measure the resistance between the harness connector terminal and chassis ground when the door lock switch is moved to UNLOCK.
Connector & terminal 
(i84) No. 29 - Chassis ground: 		 Is the resistance less than 10 Ω? The door lock switch is OK. Go to step 4. 
4 CHECK DOOR LOCK SWITCH. 
  1. Disconnect the door lock switch harness connector (D7 or D125).
  2. Measure the resistance between the door lock switch terminals when moving the door lock switch to LOCK.

Connector & terminal 
Driver's side: 
(D7) No. 5 - No. 9: 
Passenger's side: 
(D125) No. 2 - No. 5: 		 Is the resistance less than 1 Ω? Go to step 5.  Replace the door lock switch.
5 CHECK DOOR LOCK SWITCH. 
Measure the resistance between the door lock switch terminals when moving the door lock switch to UNLOCK.
Connector & terminal 
Driver's side: 
(D7) No. 5 - No. 8: 
Passenger's side: 
(D125) No. 4 - No. 5: 		 Is the resistance less than 1 Ω? Check the harness for open circuits or shorts between the body integrated unit and the door lock switch. Replace the door lock switch.
scientia non olet · About LEMON Manuals