LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Instrumentation System & Driver Information Center) >> Combination Meter System >> Inspection >> Check VDCCM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check VDCCM

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Check Yes No
1 CHECK VEHICLE SPEED SIGNAL. 
  1. Lift up the vehicle and support it with rigid racks.
  2. Drive the vehicle faster than 10 km/h (6 MPH).
    WARNING: Be careful not to be dragged in by the rotating wheel.
  3. Measure the voltage between combination meter connector and chassis ground.

    Connector & terminal 

    (i10) No. 27 (+) - Chassis ground (-): 

 Is the voltage less than 1 V ←→ 5 V or more? Replace the meter case assembly. Go to step 2  .
2 CHECK HARNESS BETWEEN VDCCM AND COMBINATION METER. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from VDCCM and combination meter.
  3. Measure the resistance between VDCCM harness connector and combination meter harness connector.

    Connector & terminal 

    (B310) No. 10 - (i10) No. 27: 

 Is the resistance less than 10 Ω? Check the VDCCM. Refer to CLEAR MEMORY MODE . Repair the wiring harness.
scientia non olet · About LEMON Manuals