Control Items
WARNING: This page is about a different variant/trim than selected.
| Control items | Control details | ||
|---|---|---|---|
| Transmission hydraulic control | Shifting control | Shift pattern selection | Based on the shift pattern selected by input from switches in each range, upshift and downshift points are set according to accelerator pedal opening angle and vehicle speed. |
| Linear solenoid control for each shift clutch | Directly controls the linear solenoid for each shift clutch according to target gear range. The control values are constantly corrected by learning control and real-time feedback, contributing shifting quality improvement and prevention of quality aging. | ||
| Engine brake control | In manual mode, controls high&low reverse clutch solenoid so that engine brake is applied at 1st speed. | ||
| Lock-up control | Basic lock-up control | Based on the shift pattern selected by input from switches in each range, lock-up engagement and release points are set according to accelerator pedal opening angle and vehicle speed. In accordance with these points, the lock-up solenoid is controlled to engage and release the lock-up clutch in torque converter. | |
| Smooth control | In lock-up clutch engagement, gradually changes pressure to provide smooth engagement. | ||
| Line pressure control | Controls the line pressure in accordance with the input torque, front vehicle speed signal, rear vehicle speed signal and gear range. | ||
| AWD center differential control | Normal transfer control | Torque sensitive control | Adjusts the multi-plate clutch (LSD) pressure according to torque input to the transfer. |
| Control for turning | Adjusts the LSD pressure based on the steering angle and vehicle speed. | ||
| Slip control | LSD pressure increases if front or rear wheels start to slip. | ||
| Cooperation control | Control during ABS operation | LSD pressure is adjusted to the set value during ABS operation. | |
| Control during braking | LSD pressure is adjusted to the set value while the brake switch is ON with the throttle valve fully closed. | ||
| Control during VDC and TCS operation | LSD pressure is adjusted to the set value during VDC and TCS operation. | ||