Radiator Cap: Inspection
WARNING: This page is about a different variant/trim than selected.
- Check that the radiator cap does not have deformation, cracks or damage.
- Attach the radiator cap tester to radiator cap.
- Increase pressure until the radiator cap tester gauge needle stops. Radiator cap is functioning properly if it holds the service limit pressure for 5 - 6 seconds. Replace the radiator cap if its valve opens at less than the service limit.
Standard:
93 - 123 kPa (0.95 - 1.25 kgf/cm 2 , 14 - 18 psi)
Service limit:
83 kPa (0.85 kgf/cm 2 , 12 psi)
CAUTION: Be sure to remove foreign matter and rust from the cap in advance. Otherwise, results of pressure test will be incorrect.