Direct Clutch Assembly

WARNING: This page is about a different variant/trim than selected.

Check the clearance of direct clutch.
Measure the clearance "L" between snap ring and retaining plate using a thickness gauge. If it is out of specification, replace the entire direct clutch assembly.
Check for damage on the drive plate, driven plate and snap ring, and replace the entire direct clutch assembly if damaged.

Standard:

0.6 - 1.0 mm (0.024 - 0.039 in)

Fig 1: Measuring Clearance Between Snap Ring And Retaining Plate Of Direct Clutch Assembly Using Thickness Gauge

Courtesy of SUBARU OF AMERICA, INC.