General Scan Tool

Check that no DTC remains after clearing memory. Refer to Clear Memory Mode .
Warm up the engine.
Connect the delivery (test) mode connector (A) located under the glove box.

Fig 1: Identifying Delivery (Test) Mode Connector Located Under Glove Box
Courtesy of SUBARU OF AMERICA, INC.
Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.

Fig 2: Connecting General Scan Tool To Data Link Connector Located In Lower Portion Of Instrument Panel (On Driver's Side)
Courtesy of SUBARU OF AMERICA, INC.
Start the engine.
NOTE: Ensure the selector lever is placed in "P" range before starting.
Turn the neutral position switch to ON using select lever.
Depress the brake pedal to turn the brake switch ON.
Keep the engine speed in 2, 500 - 3, 000 RPM range for 40 seconds.
Shift the select lever in the "D" range and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When engine control system diagnosis is finished, perform the VDC memory clearance procedure of self-diagnosis function. Refer to CLEAR MEMORY MODE Clear Memory Mode.
Using the general scan tool, check for DTC and record the result(s).
NOTE:
- For detailed operation procedures, refer to the general scan tool operation manual.
- For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
Refer to List of Diagnostic Trouble Code (DTC) .