Inspection steps
WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Check brake switch.
- Check the brake switch. (Refer to
PARTS LOCATION
)
Criteria: The switch and its installation position is correct.
NG: Replace the switch main body or adjust its installation position.
OK: Go to next step
- Check the brake switch. (Refer to
PARTS LOCATION
)
- Check brake switch circuit.
- Turn the ignition switch to OFF.
- Disconnect the parking brake switch connector.
- Turn the ignition switch to ON.
- Measure the voltage between connector terminal and chassis ground.
VOLTAGE SPECIFICATIONInspection terminals Inspection conditions Standard value A22-1 - chassis ground Always 10V or more A13-3 - chassis ground Always 10V or more NG: Check the fuse, and repair or replace the harness.
OK: Go to next step
- Check brake switch circuit.
- Turn the ignition switch to OFF.
- Disconnect the ECM connector.
- Turn the ignition switch to ON.
- Measure the resistance between ECM connector and brake switch.
STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)Inspection terminals Inspection conditions Standard value A33-7 (BRK1) - A22-4 Always Less than 10 Ω A33-3 (BRK2) - A22-2 Always Less than 10 Ω NG: Repair or replace the harness.
OK: Go to next step
Replace the ECM.