Circuit description

With the electrical key transmitter sub-assembly in the vehicle interior, press the engine switch. The collation ECM (smart key ECM ASSY) receives the signal and the power mode changes. With the shift lever in P *1 or N *1, if you step on the brake pedal *1 or the clutch pedal *2 and press the engine switch, you can start the engine.

*1: With automatic transmission

*2: for manual transmission

NOTE:

Only if the steering lock is unlocked, even if the shift lever is in the N position, you can start the engine. *
In IG ON, if the shift lever is in a position other than P, if you press the engine switch, the power changes to ACC ON. After that, if you move the shift lever to P and press the engine switch while stepping on the brake pedal, the power changes to IG OFF. *
If you remove and then reconnect the battery cable, the power returns to the mode it was before you removed the cable.

*: for automatic transmission

RELATED [CURRENT DATA DISPLAY & SAVE] AND [SYSTEM OPERATION CHECK MODE] ITEMS

Diagnostic codes	[Current Data Display & Save] items	[System Operation Check Mode] items
[The engine does not start.]	Power supply [Stop Light Switch 11] [Steering unlock SW] [Shift P signal1] [Neutral SW/Clutch SW] [IG2 relay monitor (outside)] [IG2 relay monitor (inside)] [ACC relay monitor] [IG1 relay monitor (outside)] [IG1 relay monitor (inside)] [Starter request signal monitor] [Power supply status] Collation [Engine start permission request reception status] [L Code Check] Engine [Starter Switch] [Shift SW Status (P Range)1] [Shift SW Status (N Range)1] [Ignition]	-