Basic Inspection: Notes
WARNING: This page is about a different car, the 2019 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When it is impossible to locate the defective part after troubleshooting, perform the following basic inspection to determine the problem.
- Battery check
- Check the battery condition. (Refer to ON-VEHICLE INSPECTION )
- Cranking operation inspection
- Check that the engine is cranked.NOTE: If not, refer to symptom table. (Refer to Symptom table )
- Check that the engine is cranked.
- Engine starting inspection
- Check that the engine starts.NOTE: If not, refer to symptom table. (Refer to Symptom table )
- Check that the engine starts.
- Air filter inspection
- Check the air filter.NOTE: When the air filter is dirty, clean or replace it.
- Check the air filter.
- Idle speed check
- Check the idle speed. (Refer to ENGINE (FA20) )
- Ignition timing inspection
- Check the ignition timing. (Refer to ENGINE (FA20) )
- Fuel pressure check
- Check the fuel pressure. (Refer to FUNCTION INSPECTION )
- Spark Inspection
- Check the spark. (Refer to FUNCTION INSPECTION )
- Compression inspection
- Check the compression. (Refer to ENGINE (FA20) )