LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> BRZ Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Cruise Control System) >> Cruise Control System >> Cancel Code 11 >> Inspection Steps
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Steps

WARNING: This page is about a different car, the 2019 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check cruise control main switch circuit.
    1. Remove the driver's airbag module.
    2. Disconnect the cruise control command switch connector.
    3. Turn the ignition switch to ON.
    4. Measure the voltage between connector terminal and chassis ground.
    VOLTAGE SPECIFICATION

    Inspection terminals Inspection conditions Standard value
    Z8-11 - chassis ground IG ON 5V or more

    NG: Check the roll connector, and repair or replace the harness.

    OK: GO to next step

  2. Check cruise control main switch circuit.
    1. Turn the ignition switch to OFF.
    2. Measure the resistance between connector terminal and chassis ground.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Z8-10 - chassis ground Always Less than 10 Ω

    NG: Check ECM and roll connector, and repair or replace the harness.

    OK: Go to next step

  3. Check cruise control main switch circuit.
    1. Measure the resistance when the cruise control main switch is not in operation.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Cruise control main switch side connector terminal 10 - cruise control main switch side connector terminal 11 IG ON 1 MΩ or more

    NG: Replace the cruise control main switch.

    OK: Go to next step

  4. Check cruise control main switch circuit.
    1. Measure the resistance when the cruise control ON-OFF switch is pressed.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Cruise control main switch side connector terminal 10 - cruise control main switch side connector terminal 11 IG ON Less than 1 Ω

    NG: Replace the cruise control main switch.

    OK: Go to next step

  5. Check cruise control main switch circuit.
    1. Measure the resistance when the CANCEL switch is pressed.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Cruise control main switch side connector terminal 10 - cruise control main switch side connector terminal 11 Always Approx. 1540 Ω

    NG: Replace the cruise control main switch

    OK: Go to next step

  6. Check cruise control main switch circuit.
    1. Measure the resistance when the -SET switch is pressed.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Cruise control main switch side connector terminal 10 - cruise control main switch side connector terminal 11 Always Approx. 630 Ω

    NG: Replace the cruise control main switch.

    OK: Go to next step

  7. Check cruise control main switch circuit.
    1. Measure the resistance when the +RES switch is pressed.
    STANDARD VALUE RESISTANCE SPECIFICATION (OPEN CIRCUIT CHECK)

    Inspection terminals Inspection conditions Standard value
    Cruise control main switch side connector terminal 10 - cruise control main switch side connector terminal 11 Always Approx. 240 Ω

    NG: Replace the cruise control main switch.

    OK: Go to next step

    Replace the ECM.

scientia non olet · About LEMON Manuals