LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Forester X, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H4DO) >> System Operation Check Mode >> Operation >> Idle Speed Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Speed Control

CAUTION: After executing the system operation check mode, execute the Clear Memory Mode. < Refer to OPERATION , Clear Memory Mode. >
  1. On «System Operation Check Mode» display, select {Idle Speed Control}.
  2. On «Start the Engine» display, start the engine and click the [OK] button.
  3. In the «Idle Speed Control» display, click the [↑] button or the [↓] button to change the setting values, then click the [OK] button.

    Setting is possible in a range between 500 rpm - 2, 000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle.

  4. Click the [Cancel] button to stop the idle speed control.
  5. Click the [[f12]Exit] button to end the idle speed control. The screen will return to the «System Operation Check Mode» screen.
    NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
scientia non olet · About LEMON Manuals