Common Specifications & Procedures
FORESTER COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATION | ||
| Torque | See Torque Specifications in text or applicable graphics under COMPONENT . | ||
| Axle Shaft Nut (Front) | 162.3 Ft. Lbs. (22.4 kgf-m, 220 N.m) | ||
| Axle Shaft Nut (Rear) | 140.1 Ft. Lbs. (19.4 kgf-m, 190 N.m) | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF AIR BLEEDING |
||
| Disc/Drum Brakes | SPECIFICATION | ||
| Torque | See Torque Specifications in text or applicable graphics under COMPONENT . | ||
| Charging | |||
| Generator | |||
| H4DOTC (Turbocharged) | GENERATOR | ||
| Torque (H4DOTC ) | Bolt: 18.4 Ft. Lbs. (25 N.m) Slider Bolt: 5.9 Ft. Lbs. (8 N.m) |
||
| Drive Belts | |||
| Belt Routing & Adjustment | |||
| H4DOTC (Turbocharged) | INSPECTION | ||
| Engine Cooling | |||
| H4DOTC (Turbocharged) | |||
| General Service Specifications | SPECIFICATION | ||
| Radiator Cap Pressure | 14-18 psi (.95-1.25 kg/cm2 ) | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| H4DOTC (Turbocharged) | |||
| COMPRESSION Compression (at 200-300 RPM) |
142-171 psi (981-1, 177 kPa, 10-12 kgf/cm2 ) | ||
| Oil Pressure | At Idle Speed: 14 psi (1.0 kg/cm2
) At 5, 000 RPM: 43 psi (3.0 kg/cm2 ) |
||
| Overhaul | SPECIFICATION | ||
| Torque | See Torque Specifications in text or applicable graphics under COMPONENT . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 22.1 Ft. Lbs. (30 N.m) Plus additional 30-35 degrees |
||
| Fuel System | |||
| H4DOTC (Turbocharged) | |||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Pressure Specification | With vacuum: 33-38 psi (230-260 kPa) Without vacuum: 41-46 psi (284-314 kPa) |
||
| Fuel Filter Location | In-Tank Type as part of Fuel Pump Module | ||
| H4DOTC Fuel Filter R & I |
FUEL PUMP | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | |||
| H4DOTC | Engine has coil-on-plug ignition. | ||
| Spark Plug | |||
| H4DOTC (Turbocharged) | |||
| Type | NGK: SILFR6A | ||
| Gap | 0.028-0.031 in. (0.7-0.8 mm) | ||
| Torque | 15.5 Ft. Lbs. (21 N.m) | ||
| Starting | |||
| Starter | |||
| H4DOTC (Turbocharged) | STARTER | ||
| Torque (H4DOTC) | INSTALLATION | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | WHEEL ALIGNMENT | ||
| Rear | WHEEL ALIGNMENT | ||
| Torque | |||
| Front | FRONT SUSPENSION | ||
| Rear | SPECIFICATION | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 N.m (10.2 kgf-m, 73.8 ft-lb) | ||