Front Strut: Installation
- Install the strut mount at the upper side of strut to body, and tighten it with new self-locking nuts.
Tightening torque:
20 N.m (2.04 kgf-m, 14.8 ft-lb)
- Align alignment marks on the camber adjusting bolt and strut.
Using new self-locking nuts, install the strut to the front axle housing.
NOTE: While holding the head of adjusting bolt, tighten the self-locking nut.Tightening torque:
155 N.m (15.81 kgf-m, 114.3 ft-lb)
- Secure the ABS wheel speed sensor harness to the strut.
- Install the brake hose bracket.
Tightening torque:
33 N.m (3.36 kgf-m, 24.3 ft-lb)
- Install the front wheels.
Tightening torque:
120 N.m (12.24 kgf-m, 88.5 ft-lb)
- Inspect the wheel alignment and adjust if necessary. Refer to
ADJUSTMENT , Wheel Alignment.CAUTION: When the wheel alignment has been adjusted, perform the 0 point setting mode for each sensor in the VDCCM&H/U. Refer to ADJUSTMENT .