Check Warning Buzzer For Key Left In Ignition (Model Without Keyless Access)

Step	Check	Yes	No
1 CHECK KEY WARNING SWITCH ALARM. Insert the key into ignition key lock. Open the driver's side door.	Does the buzzer sound from the meter?	Normal	Go to step 2 .
2 CHECK COMMUNICATION STATUS. Prepare the Subaru Select Monitor. On «System Selection Menu» display, select {Integ. unit mode}. On {Current Data Display & Save}, select {key-lock warning SW}. Insert and remove the key.	Does the display change between ON ↔ OFF?	Go to step 3 .	Check the ignition circuit. Refer to INSPECTION .
3 CHECK COMMUNICATION STATUS. On {Current Data Display & Save}, select {Driver's door SW input}. Open and close the door.	Does the display change between ON ↔ OFF?	Go to step 4 .	Check the door switch circuit. Refer to CHECK DOOR LOCK SWITCH .
4 CHECK COMMUNICATION STATUS. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor". On «System Selection Menu» display, select {Integ. unit mode}. Select {Diagnostic Code(s) Display}.	Is DTC being displayed?	Perform the diagnosis according to DTC. Refer to LIST .	Go to step 5 .
5 CHECK COMBINATION METER. Perform the self-diagnosis of combination meter. Refer to SELF-DIAGNOSIS DISPLAY MODE .	Did the buzzer sound?	Go to step 6 .	Replace the meter case assembly.
6 CHECK COMBINATION METER. Remove the combination meter. Attach the buzzer to another vehicle on which the buzzer operates normally to check its operation.	Did the buzzer sound?	Replace the body integrated unit. Refer to BODY INTEGRATED UNIT .	Replace the meter case assembly.