Brake Pipe: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions for the airbag system in this case. < Refer to CAUTION , General Description. >
- Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
- When installing the brake pipe, do not bend.
- After installing the brake pipe and hose, perform air bleed.
- After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
Brake pipe tightening torque:
Refer to COMPONENT of "General Description".
Front brake pipes & hoses: < Refer to FRONT BRAKE PIPES AND HOSES , COMPONENT, General Description. >
Center and rear brake pipes & hoses: < Refer to CENTER AND REAR BRAKE PIPES & HOSES , COMPONENT, General Description. >