LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Vehicle Dynamics Control (VDC) System) >> Front ABS Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front ABS Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Disconnect the ABS wheel speed sensor connector located next to the front strut mounting house in the engine compartment.
  3. Remove the bolts and then remove the sensor harness bracket.
    Fig 1: Locating ABS Wheel Speed Sensor Connector Bracket Mounting Bolt
    G08565573Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the bolts which secure the sensor harness to the front strut.
  5. Remove the bolts, and remove the front ABS wheel speed sensor from the front housing.
    CAUTION:
    • Be careful not to damage the sensor.
    • Do not apply excessive force to the sensor harness.
    Fig 2: Locating Front ABS Wheel Speed Sensor Harness Bracket Mounting Bolts
    G05957084Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals