Symptom Chart
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When measuring the voltage and resistance of each control module or sensor, use a tapered pin with a diameter of less than 0.64 mm (0.025 in) in order to avoid poor contact. Do not insert the pin more than 2 mm (0.08 in).
| Symptoms | Repair order | Note |
|---|---|---|
| Combination meter assembly does not operate. |
|
< Refer to CHECK POWER SUPPLY AND GROUND CIRCUIT , INSPECTION, Combination Meter System. > |
| Speedometer does not operate. |
|
< Refer to CHECK VDC CONTROL MODULE , INSPECTION, Combination Meter System. > |
| Tachometer does not operate. |
|
< Refer to CHECK ENGINE CONTROL MODULE (ECM) , INSPECTION, Combination Meter System. > |
| Fuel gauge does not operate. |
|
< Refer to CHECK FUEL LEVEL SENSOR , INSPECTION, Combination Meter System. > |
| Engine coolant temperature gauge or engine coolant temperature indicator light/engine coolant temperature warning light does not operate. |
|
< Refer to CHECK ENGINE COOLANT TEMPERATURE SENSOR , INSPECTION, Combination Meter System. > |
| ECO gauge does not operate. (model with luminescent meter) |
|
< Refer to
CHECK ECO GAUGE (MODEL WITH LUMINESCENT METER) , INSPECTION, Combination Meter System. >
NOTE:
The ECO gauge does not operate unless the vehicle is driven at least 1 km after the trip meter is reset.
|
| Warning buzzer for key left in ignition does not sound. |
|
< Refer to CHECK WARNING BUZZER FOR KEY LEFT IN IGNITION , INSPECTION, Combination Meter System. > |