LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Air Bag System) >> Airbag Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if the damage from water is suspected, replace the airbag control module with a new part.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
  3. Remove the console box. < Refer to REMOVAL , Console Box. >
  4. Remove the console front panel. < Refer to CONSOLE FRONT PANEL , REMOVAL, Center Console. >
  5. Remove the audio.
  6. Disconnect the connector from airbag control module.
  7. Remove the three bolts and remove airbag control module.
    Fig 1: Locating Airbag Control Module Bolts
    G05957538Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals