Front Sub Sensor: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install each part in the reverse order of removal.

CAUTION:

Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
After the installation of headlight assembly, be sure to perform headlight beam adjustment.

Tightening torque:

13 N.m (1.32 kgf-m, 9.6 ft-lb)