DTC 2B ODS System Wrong Parts: DTC Detecting Condition
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Wrong airbag control module is installed.
- Wrong occupant detection system is installed.
| Step |
Check |
Yes |
No |
1 CHECK OCCUPANT DETECTION SYSTEM.
- Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
- Replace the passenger's seat cushion pad frame assembly. < Refer to
REMOVAL
, Front Seat. > < Refer to
DRIVER'S SEAT (POWER SEAT)
, DISASSEMBLY, Front Seat. >
- Connect the ground cable to battery.
- Connect Subaru Select Monitor to the vehicle and perform the system calibration. < Refer to
SYSTEM CALIBRATION (REZEROING) . >
|
Did the system calibration complete properly? |
Finish the diagnosis. |
Go to step 2
. |
2 CHECK AIRBAG CONTROL SYSTEM.
- Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
- Replace the airbag control module. < Refer to
REMOVAL
, Airbag Control Module. >
- Connect the ground cable to battery.
- Connect Subaru Select Monitor to the vehicle and perform the system calibration. < Refer to
SYSTEM CALIBRATION (REZEROING) . >
|
Did the system calibration complete properly? |
Finish the diagnosis. |
Check between the occupant detection control module and airbag control module. |