LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Cruise Control System (Diagnostics)) >> Subaru Select Monitor >> Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Subaru Select Monitor: Operation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Selector Monitor) using a USB cable.
    NOTE: Port exclusively for Subaru Select Monitor refers to the USB port used when installing Subaru Select Monitor.
  4. Connect the diagnosis cable to the SDI.
  5. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 1: Locating Data Link Connector
    G05663967Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  6. Turn the ignition switch to ON.
  7. Start the PC.
  8. Run the "PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals