LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (H6DO)) >> Fuel Pump Control Unit >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Control Unit: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Remove the trunk trim panel assembly - side on the RH side. (Sedan model) Refer to REMOVAL .
  3. Remove the right side rear quarter trim. (OUTBACK model) Refer to REMOVAL .
  4. Remove the fuel pump control unit.
    • Sedan model
      Fig 1: Locating Fuel Pump Control Unit (Sedan Model)
      G06651309Courtesy of SUBARU OF AMERICA, INC.
    • OUTBACK model
      Fig 2: Locating Fuel Pump Control Unit (OUTBACK Model)
      G06651310Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the connector from fuel pump control unit.
    • Sedan model
      Fig 3: Locating Fuel Pump Control Unit Connector (Sedan Model)
      G06651311Courtesy of SUBARU OF AMERICA, INC.
    • OUTBACK model
      Fig 4: Locating Fuel Pump Control Unit Connector (OUTBACK Model)
      G06651312Courtesy of SUBARU OF AMERICA, INC.