LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Continuously Variable Transaxle (CVT)) >> General Description >> Preparation Tool >> General Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

General Tool

WARNING: This page is about a different variant/trim than selected.
TOOL NAME REMARKS
Circuit tester Used for measuring resistance and voltage.
Thickness gauge Used for measuring the clearance in reverse brake, forward clutch and transfer clutch.
Caliper Used for measuring the dimension.
Spring scale Used for measuring the starting torque of the drive pinion.
TORX® bit T70 Used for removing and installing differential gear oil drain plug.
Straight pin remover Used for removing and installing the straight pin.
Push/pull gauge Used for measuring clutch clearance.
Chain sling Used for removing and installing transmission.
  • Length: 0.8 - 1 m (2.6 - 3.3 ft)
  • Load capacity: 1.2 t (2, 646 lb) or more
  • Diameter: 6 mm (0.24 in) or 6.3 mm (0.25 in)
  • Chain external width: 23.5 mm (0.93 in) or less
  • Chain internal width: 8.5 mm (0.33 in) or more
Screw shackle Used for removing and installing transmission.
  • Load capacity: 250 kg (551 lb) or more
  • Use two pieces.
scientia non olet · About LEMON Manuals