LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Occupant Detection System (Diagnostics) >> Basic Diagnostic Procedure >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Basic Diagnostic Procedure: Procedure

Step Check Yes No
1 CHECK WARNING LIGHT. 
Check whether the airbag warning light in the combination meter is lit.
Does the airbag warning light illuminate? Go to step . Perform the diagnosis according to phenomenon of the problem.
2 READ DTC. 
  1. Turn the ignition switch to OFF.
  2. Connect the Subaru Select Monitor to data link connector.
  3. Turn the ignition switch to ON and run the Subaru Select Monitor.
  4. Read the DTC. Refer to OPERATION .
    NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Refer to COMMUNICATION FOR INITIALIZING THE AIRBAG SYSTEM IS IMPOSSIBLE .
  5. Record all DTCs and freeze frame data.
Is DTC displayed? Go to step . Go to "Airbag Warning Light Failure" Refer to AIRBAG WARNING LIGHT FAILURE .
3 PERFORM DIAGNOSIS. 
  1. Determine the possible cause from "List of Diagnostic Trouble Code (DTC)" Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
  2. Inspect the DTC using "List of Diagnostic Trouble Code (DTC)".
  3. Repair the trouble cause.
  4. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  5. Perform the Inspection Mode. Refer to INSPECTION MODE .
  6. Read any other DTCs displayed.
Is DTC displayed? Perform the procedure 1) to 5) in step 3. Finish the diagnosis.