Rearview Camera System: Inspection

Park the vehicle at the level place where there are enough area at the rear of the vehicle.
Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.
NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.

Fig 1: Identifying Tape Applying Areas On Vehicle
Courtesy of SUBARU OF AMERICA, INC.
Confirm the following before checking the corresponding items.
- Navigation
  - If the display is blank.
    Rearview camera image is not displayed. (Navigation screen is displayed normally.)
    1. Check the condition of back sensor connection. Refer to CHECK EACH VEHICLE SIGNAL .
    2. Check the condition of rearview camera connection. Refer to CHECK EACH CONNECTION .
  - If the marker is not displayed.
    1. Check the UART communication. Refer to CHECK EACH CONNECTION .
  - If the marker position is not aligned.
    1. Adjust the marker position according to the MARKER ADJUSTMENT MODE. Refer to MARKER ADJUSTMENT MODE .
- Rearview mirror (RCD model)
  - If the rearview camera display is blank.
    1. Check the condition of back sensor connection. Refer to CHECK EACH VEHICLE SIGNAL .
    2. Check the condition of rearview camera connection. Refer to CHECK EACH CONNECTION .