Rearview Camera System: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If the urethane foam of connector is removed during removal, be sure to apply new urethane foam.
Be sure to confirm the marker position, whenever the rearview camera is removed/installed/replaced.

Install each part in the reverse order of removal.

Tightening torque:

Rear gate garnish: 4.5 N.m (0.46 kgf-m, 3.3 ft-lb)

Rear wiper motor & wiper arm: < Refer to REAR WIPER , COMPONENT, General Description. >