Section 12 (Clutch System): Flywheel: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Temporarily tighten the crankshaft position sensor plate and flywheel.
NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
Attach the ST.
ST 498497100 CRANKSHAFT STOPPER

Fig 1: Attaching ST To Flywheel
Courtesy of SUBARU OF AMERICA, INC.
Tighten the flywheel mounting bolts in two stages.
1. Tighten the flywheel attachment bolts.
  Tightening torque:
  
  30 N.m (3.1 kgf-m, 22.1 it-lb)
  
  Fig 2: Flywheel Mounting Bolts Tightening Sequence
  Courtesy of SUBARU OF AMERICA, INC.
2. While checking the tightening angle with the ST, further tighten the flywheel mounting bolts.
  Tightening angle:
  
  30° - 35°
  
  ST 18854AA000 ANGLE GAUGE
Install the clutch disc and cover. < Ref. to INSTALLATION , Clutch Disc and Cover . >
Install the transmission assembly. < Ref. to INSTALLATION , Manual Transmission Assembly . >