Select Lever: Disassembly

Removal of guide plate
1. Use a flat tip screwdriver to release the claws, and disconnect the connector.
  
  Fig 1: Disconnecting Connector From Guide Plate
  Courtesy of SUBARU OF AMERICA, INC.
2. Use a precision screwdriver (flat tip) to release the connector lock.
  
  Fig 2: Releasing Connector Lock
  Courtesy of SUBARU OF AMERICA, INC.
3. Use a precision screwdriver (flat tip) to pull out the connectors No. 2 and No. 3 of the shift lock solenoid connector and the connectors No. 10 and No. 11 of the manual mode switch connector.
  
  Fig 3: Pulling Out Connectors No. 2 And No. 3 Of Shift Lock Solenoid Connector Using Precision Screwdriver
  Courtesy of SUBARU OF AMERICA, INC.
4. Remove the clamp push nut and the shaft guide pin.
  
  Fig 4: Locating Clamp Push Nut And Shaft Guide Pin
  Courtesy of SUBARU OF AMERICA, INC.
5. Release the 2 claws to remove the guide plate from the base plate.
  
  Fig 5: Identifying Guide Plate Claws
  Courtesy of SUBARU OF AMERICA, INC.
Removal of solenoid unit
1. Pull out the pin and remove the solenoid unit together with the shift lock release arm as a unit.
2. Remove the shift lock release arm from the solenoid unit.
  
  Fig 6: Removing Of Solenoid Unit Pin
  Courtesy of SUBARU OF AMERICA, INC.
Removal of D rod
1. Remove the D lock clamp.
2. Remove the D lock spring and the D rod.
3. Remove the cushion D lock from the D rod.
4. Remove the bushing D lock.
  
  Fig 7: Locating D Lock Clamp
  Courtesy of SUBARU OF AMERICA, INC.
Removal of grommet
1. Remove the grommet from the base plate.
  
  Fig 8: Removing Grommet From Base Plate
  Courtesy of SUBARU OF AMERICA, INC.
Removal of arm COMPL
1. Use a pin punch 3 and hammer to drive out a pin.
  
  Fig 9: Driving Out Pin Using Pin Punch And Hammer
  Courtesy of SUBARU OF AMERICA, INC.
2. Pull out the arm COMPL from the base plate.
  
  Fig 10: Pulling Out Arm Compl From Base Plate
  Courtesy of SUBARU OF AMERICA, INC.
Removal of select lever COMPL
1. Remove the select lever COMPL together with the select arm bracket as a single unit.
  
  Fig 11: Removing Select Lever Compl
  Courtesy of SUBARU OF AMERICA, INC.
Removal of select lever arm bracket
1. Remove the select lever COMPL from the select arm bracket.
  
  Fig 12: Removing Select Lever Compl From Select Arm Bracket
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the rod and the spring from the select arm bracket.
  
  Fig 13: Removing Rod And Spring From Select Arm Bracket
  Courtesy of SUBARU OF AMERICA, INC.
Removal of gasket
1. Remove 4 spacer plates to remove the gasket.
  
  Fig 14: Locating Spacer Plates
  Courtesy of SUBARU OF AMERICA, INC.
Removal of swivel
1. Remove the snap pin, then remove the 2 washers, bushing, spacer, and swivel.
  
  Fig 15: Locating Snap Pin
  Courtesy of SUBARU OF AMERICA, INC.