Read data list
CAUTION:
The values indicated under the normal conditions in the table below are informative values. Do not depend on reference value only when judging if the part is faulty.
NOTE:
By using the SSM3 for reading the data list, it is able to read the values and the status of the switches, sensors, or actuators without removing these parts. This inspection is very useful because it allows an operator to read any intermittent conditions or signals without disturbing parts or wiring. By reading the current data display & save information at an initial phase of troubleshooting, you can save time for diagnosis.
- Turn IG SW to OFF.
- Connect the SSM3 to the DLC3.
- Turn IG SW to ON.
- Turn on the SSM3.
- Enter the following menus. [Integ. unit mode] →[Current Data Display & Save]
- Using SSM3, read the data list according to the screen displays.
MAIN BODY
| Item Name |
Description/display range |
Normal condition |
Remarks |
| [Ignition] |
Ignition switch signal / ON or OFF |
OFF: IG SW OFF
ON: IG SW ON |
- |
| [ACC SW] |
Ignition switch ACC signal / ON or OFF |
OFF: IG SW OFF
ON: IG SW ACC |
- |
| [Key Unlock Warning SW] |
Unlock warning switch / OFF or ON |
OFF: Ignition key is not inserted
ON: Ignition key is inserted |
- |
| [D Door Courtesy] |
Driver's door courtesy light switch signal / ON or OFF |
ON: Driver's door is closed
OFF: Driver's door is open |
- |